top of page

No more Dip Switches

Fed up setting dip switches on batteries then watch this šŸ™‚šŸ‘šŸ‘



Ā 
Ā 
Ā 

13 kommentarer


jvanzyl
jvanzyl
15 juni 2024

Good day. So I have installed a 10kw system with 2x 15.92kw systems and done exsactley this.

Now have a problem and cannot get resolved batteries not charging over 85%?

No sure if someone can check on system what is the problem but getting frustrated with this now.




Gilla

Cobus Els
Cobus Els
27 sep. 2022

Hi

Problem is to get the link cable for the two batteries or the pin out for link in, link out port.

Gilla

alaa makki
09 aug. 2022

Hi,i have connect two inverters in parallel 8kw,as far as I understood the DG dry contact wont work,the solution is to run DG as grid feeding with ATS. Does anybody face this issue

Gilla

towerkop
14 juli 2022

Any chance of an answer to my question if the newest batteries can be added to existing previous gen ones?

Gilla

Andrey Vrey
10 juli 2022

Good day. I had a Sunsynk inverter installed in my house. Our electrical law say we need a earth leakage (EL) in the DB when the inverter is bypassed. My EL has been bypassed by the installer. Please supply me with a wiring diagram to rectify this issue so that the inverter does not trip due to different neutral connections. Regards Andrey

andreyvrey@gmail.com

Gilla
towerkop
14 juli 2022
Svarar

Hi Andrey

A firmware change a few months ago forced the usage of a relay that needs to be wired in by the installer, not difficult, but needs to be done correct and the trigger wires connected, as well as settings (signal island mode) enable, but only once the correct hardware is in place. Keith did three videos on the topic of earth leakage etc, but unfortunately no videos on the process,

as a qualified person needs to do it.


If you don’t have it in place, you will have a floating neutral when in loadshedding, which might cause some tripping, but often not. Best to chat to the electrical engineers about IF this 110V floating can cause damage or…


Gilla
bottom of page